Download PARTS LIST XM Radio Unit Kit (sold separately): P/N 08A15-EX5-000 XM Radio unit XM Radio Antenna Kit (sold separately): P/N 08A15-EX5-100A XM Radio antenna XM Radio Attachment Kit (sold separately): P/N 08B15-S9A-100 XM Radio bracket A XM Radio bracket B Wire tie 2 Wire tie with clips EPT sealer 2 Washer-bolt, 6 x 12 mm 7 Cushion tapes 4 Screws, 5 x 8 mm 4 Washers TOOL AND SUPPLIES REQUIRED Phillips screwdriver Flat-tip screwdriver Isopropyl alcohol Shop towel 10 mm Combination wrench Clip remover Diagonal cutters Ratchet wrench 10 mm and 14 mm socket Scissors INSTALLATION
Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Open the tailgate. 4. Fold down the rear seat-back, then fold the rear seat assemblies forward. 5. Fold the cargo area mat forward, and remove the cargo area floor. Remove the cargo storage bin. 6. Remove the two front clips from the rear trim panel. Pull up on the rear trim panel to release the five clips. 7. Remove the left rear door sill trim (three clips). 8. Release the two retaining tabs, and pull the accessory socket. Disconnect the vehicle connector from the accessory socket, and remove the accessory socket. 9. remove the bolt that secures the tie-down hook to the left rear side trim panel, and remove the tie- down hook. Open the cap, and remove the self-tapping screw that secures the hook. Remove each the hook. 10. Remove the clip, and remove the left rear side trim panel from the body panel by starting at the front. Then, release the six clips and four retaining tabs by pulling the left rear side trim panel toward you. 11. Remove the left rear pillar upper trim (five clips). 12. Gently pull up the panel seal. Take care not to damage to the side seal. 13. In the cargo area, remove the rear headliner clip by releasing the two retaining tabs. 14. Through the rear headliner clip hole, remove the nut that secures the roof cover. Discard the roof cover, and save the nut to be reused later. 15. Remove the cargo area light: Release the four retaining tabs, and remove the lens. Remove the two screws that fasten the cargo arealight, and unplug the vehicle connector. Remove the cargo arealight.
The post Honda CR-V XM RADIO INTERFACE Installation Intructions appeared first on ToManual.com.