Download TOOLS & PARTS I USED – Mag-Hytec Ford 10.5 rear differential cover – Redline #57914 75W140 gear oil, 6 quarts – 1/2″ socket & ratchet (cover bolt removal) – Flat screwdriver – Torque wrench – Drain pan – Several rags – Plastic putty paddle – Small funnel – Lacquer thinner – 1/4″ allen wrench (new cover bolt install) PROCEDURE Here’s a few pics of the Mag Hytec cover. Its a very impressive cover, complete with additional oil capacity, a magnetic dipstick, a drain plug, a 1/8 NPT port (for a temperature sending unit), and an o-ring to seal to the rear diff case. Here’s a shot of the dipstick (left) and temperature sender port. Here’s a pic of the drain plug on the bottom. Dipstick removed
Drain plug removed Here’s the stainless hardware that’s included with the cover. They also include the two sizes of allen wrenches needed for the installation of the bolts and to service the drain plug/diptstick/sender port. For some reason my kit had one extra bolt and three extra washers. Now on to the actual installation….. A piece of info, that would’ve been more useful to learn up front, is that if the spare tire is removed, I can actually sit under there and work on the diff cover with ease. I didn’t figure this out until it was time to refill the oil but it was still very helpful. I started by removing the original differential cover by removing the 12 bolts with a 1/2″ socket. I placed a drain pan and bucket under the rear end to catch the old oil. I took a few minutes to inspect the gears for any abnormal wear.
I used a few rags to wipe out the excess oil that didn’t drain, and also to cover the gears while I cleaned off the gasket mating surface. I used a plastic putty paddle and some lacquer thinner to clean off the old silicone. Next step was to install the new diff cover. Silicone sealer is not required for this cover because it uses an O-ring to seal to the diff case. Set the cover in place and install the 12 new socket head cap screws and washers (provided with the cover) finger tight. Then I tightened them to 16 ft-lbs in a “cross tight pattern” (per the instructions). Next, since my truck has a limited slip differential, I used Red Line 75W140, which already has the friction modifier in it.
The post Ford Super Duty 4×4 Mag Hytec Rear Diff Cover Install and Rear Diff Gear Oil Change 2004 F250 4×4 XLT Sport Crew Cab appeared first on ToManual.com.